NEWS

Installation of Face Fix System

2022-05-16

Views:

4


I believe that many people will use glass clips in their homes or some buildings. What is the correct installation method for the Face Fix System?

Face Fix System manufacturers


1. Positioning and laying out
The glass door is combined with fixed glass and movable glass door, and the positioning line is unified. According to the requirements of the design and construction drawings, the positioning line of the glass door is released, and the position of the door frame is determined at the same time.
2. Limit slot at the top of the mounting frame
The width of the limit groove should be two to four millimeters greater than the thickness of the glass, and the groove depth should be ten to twenty millimeters. During installation, at the beginning, two metal decorative board edges are drawn from the center line, and then the limit groove at the top of the door frame is installed according to the edge line, and the groove depth in the groove is adjusted by the glued backing plate.
3. Install the wooden base with metal finish
Fix the square wood on the ground, and glue the metal veneer to the wood with teng glue. If the aluminum alloy square tube is used, it can be fixed on the frame column with aluminum corners, or fixed on the wooden brick buried in the ground with wood screws.
4. Install the glass
Use the glass suction cup machine to suck the thick glass tightly, lift the thick glass plate and move it to the installation position. First insert the upper part of the glass into the limit slot at the top of the door frame, and then put the lower part of the glass on the bottom bracket.
5. Fixed glass
Nail two small square wooden strips inside and outside of the bottom bracket to clamp the thick glass to the middle door, apply tenng glue to the square wooden strip and glue the veneer metal to the square wooden strip.
6, injection glass glue seal
Inject glass glue to seal on both sides of the top limit groove and the bottom bracket opening, as well as the gap between the thick glass and the frame column, and scrape off the excess glass glue with a tool.
7. Glass docking
When the fixed part of the glass door needs to be spliced ​​due to its large size, the width of the seam should be 2 to 3 mm, and the edge of the glass plate should be chamfered.