NEWS

Installation method and precautions of Square Shower Bracing Bars

2021-10-15

Views:

25


What should I do if the space in the bathroom at home is too small for a shower room? In fact, there is a very simple way, and that is to install a beautiful shower curtain in the corresponding position of the bathroom. The shower curtain not only has a good waterproof and windproof effect, but also is affordable and easy to install. The following editor will share with you the installation method and precautions of Square Shower Bracing Bars for your reference.

Square Shower Bracing Bars

Square Shower Bracing Bars installation method and precautions 1

The installation of the shower curtain is very simple, we can operate it with a little learning. If your shower area has three walls, then the shower curtain is very convenient to install. We just put the shower curtain rod on the wall at both ends with a "expansion rod". The "expansion rod" is actually a telescopic iron pipe. After the two ends are plugged, it is fixed by twisting it.

Square Shower Bracing Bars installation method and matters needing attention two

If your shower area only has two walls, you can’t use the Square Shower Bracing Bars installation method above. You can only choose the arc steel to fix it on the wall. This fixed arc steel pipe has a drawback. Due to uneven force, it is easy to loosen after a long time. If there are signs of loosening, fix it in time.

Square Shower Bracing Bars installation method and precautions three

Just installing the shower curtain can not play the role of separating dry and wet, so we need to make a water retaining strip in the shower area. We generally use natural stone as a water retaining strip. The width of the water-retaining strip generally has three sizes: 3 cm, 5 cm and 6 cm. The editor thinks that 5 cm is very suitable; the height of the water-retaining strip generally has two sizes: 1 cm and 1.8 cm. My home is 1.8 cm. .

Square Shower Bracing Bars installation method and matters needing attention four

If you install the water-retaining strip after laying the floor tiles in your home, we can use glass glue to fix the water-retaining strip. It takes 24 hours for the glass glue to be silicified, so the editor recommends that you do not take a bath for two days or the like to avoid the glass glue from attracting water and affecting later use.